Right now, you get the new edition with TRACKMASTER I, COLUMN WHEEL, printed at 12 o'clock, as shown in the photo below. Everything is the same between the old and new editions except different words printed at 12 o'clock.
The upper right button is pressed to start/stop the chronograph function. The lower right button is pressed to reset after the chronograph function has been stopped. Both upper right and lower right buttons are installed with a screw-on mechanism to prevent the button from being pressed if screwed on. In the middle is the screw-on type crown, which is pulled out with one click to adjust the time. The movement has a hacking function to stop secondhand while adjusting the time.
As we all know, the Dandong 4130 chronograph automatic movement is used in high-end homage watches. This watch uses the Dandong 4801, an upgraded edition of 4130. These two movements are essentially the same except for the self-winding mechanism, of which the 4130 is double-directional winding, but the 4801 is single-directional winding. From now on, Dandong Watch Factory will only make the 4801. The old 4130 is phased out.
This 4801 automatic runs stably at a high vibration of 28800 per hour. The subdial at 3 o’clock counts minutes, with a maximum of 30 minutes. The subdial at 6 o’clock counts seconds per minute. The subdial at 9 o’clock counts hours, with a maximum of 12 hours. A central long secondhand sweeps across the dial to count seconds.
